Inflate your stand-up paddle board and canoe/kayaks to 20 PSI. This dual-action hand pump enables you to easily inflate to more than 15 PSI
Directions for use
1/ Stand on level and solid ground
2/ Check that the hose is attached on the INFLATE side
3/ Connect the hose to the inflatable
4/ Turn the orange ring to position 1
5/ Inflate the craft until it becomes difficult (approx. 8 PSI)
6/ Turn the orange ring to position 2
7/ Finish inflating to the recommended pressure.
Pump supplied with 2 seals on the inflation nozzle to fit most valves on the market. (orange: ITIWIT / black: other)
Storage instructions
Use the fastening clip to attach the hose and pump together.
Do not stand on the pump or the hose.
Clean off any sand and/or salt, as this may damage the seals.
Technical dimensions
Height: 47 cm
Width: 30 cm
Hose length: 90 cm
60 mm diameter piston for easier pressurising. Easy to inflate for everyone.
Pump weight: 1.3 kg
Sold with a set of adaptors
In addition to its standard adapter to inflate your dropstitch SUP or kayak to high pressure, the pump also comes with:
A "Mini Boston" adapter to inflate the kayak seats
a "Boston" adapter to inflate low-pressure kayaks, inflatable air mattresses and tents.
An adapter and end piece to inflate certain kitesurfing wings.
This compact, high-pressure and dual-action pump has two function modes: one to increase volume, and one to reach the right pressure of the craft.
The deflation action drains air from the craft.
Inflate your stand-up paddle board and canoe/kayaks to 20 PSI. This dual-action hand pump enables you to easily inflate to more than 15 PSI